LumaSense Technologies 3434i SF6 Leak Detector User Manual
Instruction manual
Advertising
Table of contents
Document Outline
- Index
- 3434i SF6 Leak Detector
- Chapter 1 Using this Manual
- Chapter 2 Preliminary Tasks
- Chapter 3 Philosophy of Operation
- Chapter 4 Introduction to and Familiarization with the Monitor
- 4.1 Special Terminology
- 4.2 Attaching the Sampling Tube and External Filter
- 4.3 Familiarization with the Monitor using the Front Panel
- 4.3.1 Setting the Internal Clock
- 4.3.2 Setting Units
- 4.3.3 Setting the Environment Parameters
- 4.3.4 Setting up a Monitoring Task
- 4.3.5 Store Measurement History.
- 4.3.6 Starting a Monitoring Task
- 4.3.7 Displaying Measurement Results while a Monitoring Task is in Progress
- 4.3.8 Stopping a Monitoring Task
- 4.3.9 Scrolling through Measurement Results after Completion of a Monitoring Task
- 4.3.10 Changing Gas-concentration Units after a Monitoring Task
- 4.3.11 Changing the Humidity Unit after a Monitoring Task
- 4.3.12 Changing the Pressure Unit after a Monitoring Task
- Chapter 5 The Monitor
- Chapter 6 Keying-in Parameters
- Chapter 7 Setting-up and Starting a Monitoring Task
- Chapter 8 Viewing Measurement Data – Using the Monitor
- Chapter 9 Storage of Data in the Monitor’s Memory
- Chapter 10 Using a Printer with the Monitor
- Chapter 11 Maintenance of the 3434i
- Chapter 12 Calibration of the Optical Filters
- 12.1 About the Installed Optical Filters
- 12.2 What is Calibration and Why is it Necessary?
- 12.3 Tasks Before Starting Any Calibration
- 12.4 The Basic Calibration Set-up
- 12.5 General Settings – Stand-alone Use
- 12.6 Zero-point Calibration
- 12.7 Humidity-interference Calibrations – Stand-alone Use
- 12.8 Span Calibration
- 12.9 Calibration of the Water-vapour Filter – Stand-alone Use
- 12.10 Setting-up a Combined Zero-point and Humidity-interference Calibration – Stand-alone Use
- 12.11 Setting-up any Combined Calibration – Stand-alone Use
- Chapter 13 Messages Related to Calibration
- Chapter 14 Warning and Error Messages