LumaSense Technologies 3434i SF6 Leak Detector - Manual (Page 28)

Chapter 3
______________________________________________________________________
_____________________________________________________________________________
BE6028-14 3434i SF6 Leak Detector LumaSense Technologies A/S
Page 28 of 191
3.2 Stand-alone Use
This method of operation is available to those of you who wish to use
the monitor without connection it to a PC. The monitor is set-up and
the results are displayed via the monitor’s front panel.
The structure of the monitor set-up can be viewed like an inverted
tree. The main branches divide and separate into minor branches.
These in turn divide again and again.
To move through the tree, the branches are selected using the
“select” push-buttons (see section 1.5). Use the Set-up Tree,
supplied with the monitor and the example steps below to see how
the instructions progress. Starting from the initial screen display.
1. Press SET-UP, and the text changes to that displayed below.
2. To select the MEASUREMENT branch, press S1. (Pressing either
of the other “select” push-buttons will take you along another
branch of the set-up tree. The following text is displayed.
To select the ENVIRONMENT branch, press S3. The text is
displayed.
CURRENT TIME IS 2011-06-13 17:12
MONITOR IS READY FOR USE
SELECT SET-UP BRANCH
MEASUREMENT FORMAT CONFIGURATION
SELECT SET-UP BRANCH
MONITORING TASK ENVIRONMENT