Seed Hawk Raven 2010 - Manual (Page 121)

Manual No. 016-3001-003 111
Navigating the Viper Pro Interface
1.
SCT Ready systems will control products 1 through 3 across the implement width. To ensure proper rate
control of these products, enter the implement width as the section 1 width value.
Note:
In an SCT Ready system, the first section must always set to the full drill width and is assigned to
products 1 through 3 applied from the air cart. The section 1 switch on the Seed Hawk switch box
toggles all of the air cart bins simultaneously for the entire drill width.
2.
Optional liquid products may be controlled in up to four sections using Sectional Control Technology. To
configure the remaining section widths, divide the total implement width by the number of remaining
sections.
Note:
To change the number of configured sections, touch the Prev button to go back to the Drill Setup
screen. See Chapter 7, Sectional Control Technology™ (SCT) for more information on SCT and
SCT Ready systems.
3.
Touch the OK button to accept the programmed settings and return to the Viper Pro main screen.
SCT™ Systems
The following procedure contains information for configuring section widths for Seed Hawk SCT systems. See
the SCT™ Ready Systems section on page 110 for information on the Section Width Setup screen for the
Seed Hawk SCT Ready systems.