Seed Hawk Raven 2010 - Manual (Page 39)

3
Manual No. 016-3001-003 29
CAN (Controller Area Network) Setup
Note:
These values are good starting points and generally yield adequate results, however, the speed
cal should be refined for your specific vehicle and speed sense system. See Appendix C,
Calculating Speed Calibration, for instructions on refining the speed cal value.
If another source will be used to detect vehicle speed, touch the Calibration Assistance button
and follow the on-screen instructions. The procedure in Appendix C, Calculating Speed
Calibration, should also be performed to refine or verify the initial value.
Using the Calibration Assistance:
1.
Touch within the Product Control area on the main screen.
2.
Touch within the Miscellaneous area on the CAN Controller Status screen. The Miscellaneous Settings
screen will display.
3.
Press the Calibration Assistance button below the programmed speed cal value.The Speed Calibration
screen will appear.
4.
Mark off the physical distance to be driven for the test.
5.
Enter a measured test distance, in feet, in the Test Distance box.
Note:
If Metric is selected for Units of Measure, the test distance will be in meters.
A distance of at least 500 feet [152 meters] should be entered. A shorter distance may give less
accurate results.
6.
Press Next.