Seed Hawk Raven 2010 - Manual (Page 53)

3
Manual No. 016-3001-003 43
CAN (Controller Area Network) Setup
PW Freq
Enter the coil frequency of the PWM valve in this field. The default value is 122 Hz.
Note:
PW Freq is not used with ground drive carts.
Valve Delay
Set the Valve Delay to include a time delay between when the sections are turned on and when the product
nodes start to control the flow rate. Viper activates this delay if the time between turning the section on and off
is less than 30 seconds.
Note:
A Value of zero must be entered if a Fast Close or PWM Close valve is used as the control valve
or when the Valve Type is programmed as a standard valve with an injection system.
Data Box 2 for Products 4-5
The information displayed in Data Box 2 is an overview of the settings for the selected product control node.
Note:
The selected product control node appears with a check mark in the corresponding radio button at
the top of Data Box 1. To switch the selected node, touch the radio button for the desired product
node.
Status Screen Example
(Products 1-3)