Seed Hawk Raven 2010 - Manual (Page 155)

Manual No. 016-3001-003 145
Sectional Control Technology™ (SCT)
4.
Select Apply or No-Apply.
Note:
Only one zone type can be created at a time.
5.
Select an offset shift for the boundary that is in relationship to one-half the implement width.
6.
Press OK. Viper draws the boundary line on the Scout map as you drive around the boundary.
7.
To close the boundary, press Finish.
Note:
Apply/no-apply zones do not have the auto close feature. You will need to select Finish and the
Zone to finish at the end of the boundary.
8.
To define additional apply/no-apply zones, repeat step 3 through 7 for each apply or no-apply boundary to
define.
Once a zone is created, it can be viewed on the Scout tab and on the Section Control tab. The Section
Control tab will show all finished zones as well as allow you to create the finished SCT apply/no-apply map
when all zones have been defined.
Note:
Any area not defined will default to an apply zone. However, if the create boundary selection has
been checked, it is important to create the outer boundary of the field as an apply zone.
If you have previously selected to use an existing field boundary, the selected field boundary will
be automatically created as an apply zone. The create boundary selection will automatically be
displayed and you will be able to create additional zones if desired.
Once you have created all the apply and no-apply zones desired for the job, you are ready to start the SCT
apply/no-apply map:
9.
On the main screen, select the Section Control tab.