Seed Hawk Raven 2010 - Manual (Page 212)

Appendix B
202 Seed Hawk™ Viper Pro™ Installation & Operation Manual
AutoBoom Alarms
The AutoBoom Alarms folder is created but is not used with the Seed Hawk systems. For a description of the
AutoBoom feature and this folder, refer to the Raven Viper Pro Installation & Operation Manual (P/N 016-0171-
122).BoundaryShp Folder
The boundaryShp folder contains any shapefiles for field boundaries created using GIS software and
transferred to the Viper Pro console.
Note:
Field Boundaries created using the Viper Pro are saved as a part of the job file.
Shapefiles within this folder must have the .shp, .shx, and .dbf extension.
Clone Folder
The clone sub-folder will only appear on the USB drive if a clone of the Viper Pro has been created. Clones
may be used as “restore points” to quickly and easily reset the Viper Pro console to a previous set up. A clone
will contain the following files contained within the Viper Pro file structure:
Refer to Clone or Restore Settings section on page 169 for instructions on using clone files.
CovMaps Folder
The covMaps folder contains product coverage map files that have a .cov extension. Viper saves one coverage
file for each product and each job.
It will also contain boom control data files if you have purchased the AccuBoom Control feature for the Viper
Pro system. These files have a .bct extension. Viper Pro saves one file for each job.
These files are used by the Viper Pro OS and are not viewable.
GuidanceArchive Folder
The GuideArchive folder contains the guidance A-B lines saved in files with a .ab extension.You should store
any previously created A-B lines in this folder.
These files are used by the Viper Pro OS and are not viewable.
• Coverage Maps • Job files
• Prescription Maps • Rbin files
•
Streetmaps
•
Boom Configuration
• Scout Maps • AccuBoom Configuration
• A-B Lines • Comm Port settings