Seed Hawk Raven 2010 - Manual (Page 25)

2
Manual No. 016-3001-003 15
Installation, Start Up & Registration
4.
If the Viper Pro is set as the CAN Controller, the Viper Pro will attempt to establish communication with the
CANbus system. The CAN Initialization Results screen displays the results of CANbus detection.
5.
If the status of the CAN nodes is displayed properly, touch the Start Viper button to finish the start up
sequence.
Note:
Refer to Chapter 3, CAN (Controller Area Network) Setup, for more information on the CAN
Initialization Results screen, or information on setting up or troubleshooting the CANbus or CAN
nodes.
6.
The Viper Pro Main screen will display. For a description of the features and information displayed on the
Main screen, see Chapter 4, Navigating the Viper Pro Interface.
Touch Screen Calibration Wizard
When the operator touches an area of the screen, the Viper Pro displays an arrow in the area where the
selection has been made. If this arrow does not appear in the correct location, the touch screen may require
recalibration.
There are two ways to access the Touch Screen Calibration Wizard:
• Press the power button while the start up prompt is displayed.
• Select the Calibrate Screen option at the bottom of the Program Selection Menu screen.
To complete the Touch Screen Calibration Wizard:
1.
Touch and hold in the center of the first of four calibration points.
2.
When prompted, release the point. The next calibration point will be displayed.
3.
Touch and hold the center of each remaining calibration point as they are displayed.