Seed Hawk Raven 2010 - Manual (Page 122)

Chapter 4
112 Seed Hawk™ Viper Pro™ Installation & Operation Manual
1.
Enter the width of each section configured on the previous screen starting with section 1 on the far left of the
implement.
To determine the width of a section, multiply the number of shanks in the section by the row spacing. The
number of shanks in a section may be determined by counting the supply lines on each tower of the drill.
Note:
To change the number of configured sections, touch the Prev button to go back to the Drill Setup
screen.
2.
Touch the OK button to accept the programmed settings and return to the Viper Pro main screen.