Seed Hawk Raven 2010 - Manual (Page 41)

3
Manual No. 016-3001-003 31
CAN (Controller Area Network) Setup
11.
To verify the calculated value:
a.
Press OK on the Miscellaneous Settings screen to return to the CAN Controller Status screen.
b.
Touch the Tally Registers button at the bottom of the screen.
c.
Touch the Reset button next to the Distance display on the Tally Registers screen.
d.
Re-run the same test distance driven during the Calibration Assistance procedure. If the Distance
display on the Tally Registers screen matches the measured test distance, the calculated speed cal is
correct. If the Distance display does not match, see Appendix C, Calculating Speed Calibration, for
additional speed cal calibration procedures.
Audible Alarms
Viper Pro can sound a five second alarm tone whenever a CAN alert condition is encountered (i.e. low tank or
bin, zero speed, etc. Audible Alarms are enabled by default.
Node Version Information
Pressing the Next button on the Miscellaneous Settings screen will display the Node Version Information
screen. The Node Version Information screen displays the software version, software revision, and program
number of each node currently detected by the Viper Pro CANbus.
To Access the Node Version Information screen from the Main screen:
1.
Touch in the Product Control area on the main screen.
2.
Touch within the Miscellaneous area on the CAN Controller Status screen.
1.20 (143)
Software
Version Software
Revision Program
Number