Seed Hawk Raven 2010 - Manual (Page 161)

Manual No. 016-3001-003 151
Viper Pro Guidance
8
3.
At the end of the swath, touch the ‘Set B’ button on the screen. Viper will connect the points plotted along
the contour and display the driven path with a blue line. Guidance for subsequent swaths will be based on
the original contour and the swath number will be displayed in the upper right corner of the screen.
Note:
Curvature of the Fixed Contour guidance path should not be too aggressive. Overly aggressive
curves may produce undesirable results.
Setting the Last Pass Pattern
With a job in progress, select the Guide tab at the right of the Viper Pro display.
The last pass pattern is based on coverage area and does not use A-B points to determine swath guidance.
Previously applied or covered area must be present in the job to view last pass guidance paths. Last pass
guidance is only available for swaths immediately adjacent to coverage area.
At the end of each pass, simply turn the vehicle into the next swath and the Viper Pro will detect the nearest
covered area and determine guidance.
Note:
Last pass is only available for swaths immediately adjacent to the coverage or applied areas.
Setting the Pivot Pattern
With a job in progress, select the Guide tab at the right of the Viper Pro display. To begin pivot guidance: