Seed Hawk Raven 2010 - Manual (Page 44)

Chapter 3
34 Seed Hawk™ Viper Pro™ Installation & Operation Manual
Node Settings Screen (Page 2)
Press the Next button on the first Node Settings screen to display the next page of available settings and
options.
Note:
The following sections offer descriptions of the various options and settings used with products 1
through 3. For descriptions of the settings used with products 4 and 5, see the Data Box 1 for
Products 4-5 section on page 35.
Zero Speed Shutoff
Use the Zero Speed Shutoff feature in Automatic Control Mode to allow the Viper Pro to turn off product
application if the vehicle speed drops below 0.7 MPH. To restart product application, cycle the master switch
‘Off’ and then ‘On.’ The Zero Speed Shutoff function will reactivate if the vehicle does not achieve a speed
greater than 0.7 MPH and maintain that speed for more than 10 seconds.
Note:
For products 1 through 3, the zero speed shutoff function is not recommended as this will stop
seed application if the speed detected by the speed sensor falls below 0.7 mph.
Bin Level Alarm
Enable the bin level alarm to provide an alarm if the bin level falls to 5% or lower.
Bin Pressure Alarm
Enable the bin pressure alarm to allow Viper Pro to display an alert if the bin pressure in the air cart falls below
the mechanical set point of the pressure switch.
Gate Alarm
Enable the gate alarm to provide an alert during an application if the meter gates are not in the appropriate
positions for product application.
Decimal Shift
Use the Decimal Shift feature to increase the system accuracy for low application rates. In the standard mode,
the Viper Pro displays values to one decimal place. With the Decimal Shift feature enabled, values will be
displayed to two decimal places.
Note:
After you have either enabled or disabled the Decimal Shift, verify all calibration values for
accuracy. Change settings as necessary.