Seed Hawk Raven 2010 - Manual (Page 223)

APPENDIX
F
Manual No. 016-3001-003 213
Appendix F
Updating CAN Nodes
on the Viper Pro
Console
Viper Pro consoles with version 3.0 or higher software are capable of programming nodes on the CANbus
directly through the Viper Pro console using a USB flash drive with the CAN Update program.
Note:
Before trying to update a CAN Node, make sure the node is communicating properly over the
CANbus. If the node is not communicating properly, the Viper Pro will be unable to update the
node.
The CAN Update program and node updates are available by contacting the Raven customer support center at
1-800-243-5435.
To Update CAN Nodes
1.
Start the Viper Pro and access the Program Selection Menu screen.
Note:
If the console is already powered up, touch the Menu button and select Exit. Select the Exit to
Menu option on the Exit Viper screen.
2.
Insert the USB flash drive with the CAN Update program and required .hex files into an available USB port
on the Viper Pro console.
NOTICE
Updating a CAN Node erases the current
settings in the node. To retain settings and
calibration data, be sure to write down all
settings stored by the node(s) being updated.