Canon imagePROGRAF iPF510 - Manual (Page 125)

Handling rolls
Handling rolls
Selecting the Paper Source
When advancing paper, press the Feeder Selection button and select the source.
You can determine the selected source by checking which lamp is lit-either the Auto Feed lamp (a) or the Paper
Tray lamp (b).
• Auto Feed lamp : Selected when printing on Roll Media or the Cassette.
• Paper Tray lamp : Selected when printing on Sheets from the Top Paper Feed Slot or Front Paper
Feed Slot.
Note
• If any paper is loaded that will not be used, a message is shown on the Display Screen (either Remove
RllMedia? or Remove CutSheet? ) when you press the Feeder Selection button.
To remove the paper, press the OK button. (→P.141)
• You cannot switch the paper source in the following situations:
• If the Message lamp is ashing
Check the message on the Display Screen and take action as necessary. (→P.674)
• If the Data lamp is ashing
Select the paper source after printing.
• If a printer menu operation is in progress
Select the paper source after the menu operation.
• When in the process of loading paper
Finish loading the paper before selecting the paper source.
• When in the process of replacing Ink Tanks
Finish replacing the Ink Tanks before selecting the paper source.
• If the Top Cover is open
Close the Top Cover before selecting the paper source.
Handling Paper 111