Canon imagePROGRAF iPF510 - Manual (Page 695)

Messages regarding paper
Roll Paper / Please Replace
Paper Level Low / Replace Paper
Cause Corrective Action
Hold down the Stop/Eject button for a second or
more to cancel printing, then follow these steps to
replace the roll.
1. Remove the roll.
(→P.119)
(→P.120)
(→P.121)
2. Load a roll with enough paper left.
(→P.114)
(→P.116)
(→P.117)
3. If no barcode was printed on the roll, specify the
paper type.
(→P.112)
4. Specify the paper length, unless a barcode has
been printed on the roll and you have deactivated
the automatic detection function of the remaining
roll paper.
(→P.113)
The printer has received a print job longer than the
amount of roll paper left.
Press the Online button to continue with printing.
However, the roll paper may run out during the
print job and you may not be able to print all of the
document.
Paper Not Loaded / Press ↑ Key
Cause Corrective Action
The roll is empty. Follow the steps below to replace the used roll with a
new roll of the same type and size.
1. If the last paper on the roll has not been ejected,
follow the steps below.
1. Press the ▲ button.
2. Remove the roll.
(→P.122)
3. Press the ▼ button.
2. Load a new roll.
(→P.114)
(→P.116)
(→P.117)
3. If no barcode was printed on the roll, specify the
paper type.
(→P.112)
4. Select the paper length, unless a barcode has
been printed on the roll or you have deactivated
the automatic detection function of the remaining
roll paper.
(→P.113)
Error Message 681