Canon imagePROGRAF iPF510 - Manual (Page 128)

Handling rolls
Loading Rolls on the Roll Holder
When printing on rolls, attach the Roll Holder to the roll. Attach the 2-inch or 3-inch paper core attachment to
the Roll Holder, depending on the size of the paper core of the roll you will use. The printer is delivered with
the 2-inch paper core attachment installed. (→P.139)
Important
• Align the edges of the paper on both ends of the roll.This may cause feeding problems.
• If the edge of the roll is bent or soiled, use the Paper Cutting operation of the printer to cut the edge of
the paper manually. (→P.131)
• If the paper is badly creased or bent, cut the edge of the roll with scissors before loading the roll in
the printer, and then cut the edge of the paper manually using the Paper Cutting operation of the
printer. (→P.131)
• To load a roll with a 3-inch paper core, insert the 3-Inch Paper Core Attachment on the roll holder and
attach the 3-Inch Paper Core Holder Stopper. (→P.139)
Caution
• Set the roll on a table or other at surface so that it does not roll or fall. Rolls are heavy, and dropping a
roll may cause injury.
Note
• For details on supported sizes and types of the roll that can be loaded, see “Paper Sizes” or the Paper
Reference Guide. (→P.109) (→P.103)
• If you use a roll A2 or larger for Borderless Printing, insert the provided Spacer for Borderless
Printing on the Roll Holder.
Follow the steps 3 and 4 below.
1.
Remove the Holder Stopper from the Roll Holder.
114 Handling Paper