Canon imagePROGRAF iPF510 - Manual (Page 39)

Control Panel
Turning the Printer On and Off
Turning the printer on
1.
Press the Power button to turn on the printer.
After all lamps are lit and then go off, the printer starts up.
Initializing is displayed on the top line of the Display Screen, followed by the printer model
and version number.
Initializing
2.
The printer goes online after startup, and the Online lamp and paper source section lamp
remain lit.
The printer will not go online in the following situations. Take the appropriate action.
• The Top Cover is open
Close the Top Cover.
• The Ink Tank Cover is open
Close the Ink Tank Cover.
• The Printhead is not installed
Please see “Replacing the Printhead”. (→P.611)
• Ink Tank is not installed
Please see “Replacing Ink Tanks”. (→P.600)
• If “ERROR” is shown on the Display Screen.
Turn off the printer and contact your Canon dealer.
• The Online lamp and Message lamp are not lit (even once), and nothing appears on the Display
Screen
Make sure the printer is plugged in correctly. Check the connection at the plug and electrical outlet.
Important
• Starting the printer when it is connected via the USB cable to a Macintosh computer that is off may
cause the computer to start up at the same time. To prevent this, disconnect the USB cable before
starting the printer. Connecting the printer to the computer via a USB hub may solve this issue.
Printer Parts 25