Canon imagePROGRAF iPF510 - Manual (Page 712)

Other Messages
Power On / Again
Cause Corrective Action
Fastening tape or the Belt Stopper has not been
removed inside the Top Cover. Follow the steps below, referring to the Quick Start
Guide as needed.
1. Turn the printer off.
2. Open the Top Cover and remove the tape or Belt
Stopper.
3. Turn the printer on.
There is a paper jam. Follow these steps.
1. Turn the printer off.
2. Remove the jammed paper.
(→P.169)
(→P.122)
(→P.174)
3. Turn the printer on.
4. Reload the paper.
(→P.87)
(→P.82)
(→P.89)
Turn off the printer and wait for three seconds or
more before restoring the power. There is a problem with the printer.
If the message is still displayed after this, write down
the error code and message, turn off the printer, and
contact the Canon dealer for assistance.
Power On / Again / Multi-sensor Err
Cause Corrective Action
Direct sunlight or strong lighting may be shining on
the printer and causing the sensor to malfunction. Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Cannot update rmware
Cause Corrective Action
Check the rmware version.
(→P.637) You have uploaded rmware for a different model.
If the message is displayed again, contact your
Canon dealer for assistance.
698 Error Message