AltiGen comm ACM 5.1 - Manual (Page 143)

Chapter 11: Board Configuration
AltiWare ACM 5.1 Administration Manual 129
You can configure the board type: either T1 or E1 to run T1 CAS, T1 PRI, or E1 CAS,
E1 PRI. Additional steps are needed to further configure the CAS or PRI protocol in
the Protocol Configuration window, shown in Figure 9 and Figure 10.
Figure 6. Triton T1/E1 Configuration dialog box
(For information on adding and removing mobile trunks, see “Mobile Extension
Configuration” on page 239.)
T1 and E1 Configuration
Double-clicking a channel group for a Triton T1 board in the Channel Group Info pane
opens a T1 or E1 Configuration dialog box, as in Figure 7 and Figure 8.
Figure 7. Triton T1 configuration dialog box