AltiGen comm ACM 5.1 - Manual (Page 148)

Chapter 11: Board Configuration
134 AltiWare ACM 5.1 Administration Manual
Figure 9. T1 PRI Protocol Configuration dialog box (top half)
Figure 10. T1 CAS Protocol Configuration dialog box (top half)
Selecting Span Types
•
T1 CAS—select this option to associate all channels on the span to T1 CAS.
•
Regular ISDN PRI—select this option to indicate 23B+D ISDN PRI span and to
designate the last channel as the D channel.
•
Custom ISDN PRI—select this option only when your PRI D channel is on the last
channel. AltiGen dealers should work with AltiGen Technical Support to configure
this special case.
•
Enable Tie Trunk—check this box to enable a tie trunk. Tie trunks must terminate
to a system also configured as a tie trunk.
Note: This option not available when T1 CAS is selected.