AltiGen comm ACM 5.1 - Manual (Page 260)

Chapter 18: Mobile Extension Configuration
246 AltiWare ACM 5.1 Administration Manual
Figure 7. Mobile Extension Board Configuration dialog box
•
Max Number of Extensions—If more mobile channel support is required,
change this to a larger number (256 extensions maximum), and then reboot
the system.
• Key Simulation—Check the first check box to allow the mobile phone user to
use the * key to simulate “FLASH”. Check the second check box to allow the
user to use ** to disconnect the current call and then get a dial tone without
hanging up the cell phone. The user must press the second * within 1.5
seconds.
•
“Transmit Caller ID to MobileExt through PRI” panel. Choose from:
•
Send inbound caller ID or extension number
•
Send inbound caller ID only
• Replace with following number
•
DNIS Access Numbers—If a PRI trunk is used for a mobile extension, a DNIS
access number must be set, so that AltiServ can tell if the incoming call is a
regular trunk call or a mobile extension off-hook request. Click the Add button
in this panel to add a DNIS access number. To remove a number, select it and
click the Remove button.
• Mobile Extension Ports table —displays fields for the channel, target phone
number, caller ID, trunk allocation (shared or dedicated), phrase 1 (Play Phrase
After Answered), and phrase 2 (Play Phrase Before Dial Tone) of each extension
port.
•
Mobile Trunks table—displays fields for the board, span, channel, trunk
allocation, mobile extension and status of each mobile trunk.