AltiGen comm ACM 5.1 - Manual (Page 333)

Chapter 24: Network Configuration Guidelines for VoIP
AltiWare ACM 5.1 Administration Manual 319
No special configuration is needed for Router 2. Also, more than one AltiGen SIP
phone can sit behind Router 2.
For an H.323 IP Call from Another AltiWare on the Internet
Another AltiWare can make an H.323 IP call to this AltiWare by calling the AltiWare's
public IP address, which is 169.254.101.2.
VPN Network Configuration Example
(Connecting to AltiWare with VPN)
Figure 2. AltiWare with VPN
In a multi-site configuration, VPN can be used to provide a secured tunnel between the
remote sites and the corporate site.
Figure 2 shows a network layout in which there are two private networks, the corporate
LAN and branch office LAN. The VPN tunnel connects the two private networks such that
the two networks access each other with a private IP address.
In the corporate network, AltiWare is installed on a host with private IP address
192.168.1.2.
Both Router 1 and Router 2 are VPN-capable and compatible with each other. (It is
recommended that the routers come from same vendor.) A VPN tunnel exists between
these two routers. The local IP phones—IP Phone 1 and IP Phone 2—directly connect to
the corporate network with private IP address 192.168.1.100 and 192.168.1.101. And
the three remote IP phones—IP Phone 3, IP Phone 4 and IP Phone 5—connect to the
branch office network with private IP addresses 192.168.2.100, 192.168.2.101 and
192.168.2.102, respectively.
Setup
For the Branch office LAN:
•
IP Phone 3, IP Phone 4 and IP Phone 5