AltiGen comm ACM 5.1 - Manual (Page 168)

Chapter 12: Trunk Configuration
154 AltiWare ACM 5.1 Administration Manual
H323 Tie Trunk Properties
To open a trunk configuration dialog box for an H323 tie trunk, do one of the following:
•
In the Trunk Configuration window, select an H323 trunk type, then click the
Trunk Properties button.
•
In the Board View window, double-click an H323 board type, then click the Board
Configuration button.
Board configuration is discussed in “Configuring the H323SP Board” on page 143.
Max Trunk Channel sets the maximum number of trunk channels for this board in
increments of 4, from 4 to 96. You need to stop and restart the system after the
maximum trunk channel number is changed.
Note: This is signal only trunks. Make sure you have enough IP resource boards to cover
your needs.
SIP Tie Trunk Properties
To open a configuration dialog box for a SIP tie-trunk channel, do one of the following:
• If you’re in the Trunk Configuration window, select a Triton VoIP channel from the
trunk channels list, then click the Trunk Properties button, or just double-click the
channel in the list.
•
If you’re in the Trunk View window, right-click the channel and select Channel
Properties.
The following dialog box opens:
Figure 4. Configuration dialog box for a Triton VoIP channel
See “Configuring the SIPSP Board” on page 142 for board configuration information.
Note: This is signal only trunks. Make sure you have enough IP resource boards to cover
your needs.