ARRI ARRIFLEX 416 - Manual (Page 124)


1 1
GENLOCK on/off
It is possible to synchronize the IVS to an external video
signal, thus allowing the user to switch between different
video signals without synchronizing problems.
• Connect a standard video signal of the same type as
the video system (PAL or NTSC) to the Video output
with no data (C-Output).
• Move the cursor > with the keys Ê and Ë to the line
– GENLOCK. Pressing the key Í or Ì will switch
genlock ON or OFF.
The video signal out of the connector for video with
data is now synchronized to the incoming video signal
connected to the other BNC socket.
Note: GENLOCK is only available, if the output is on
VBS mode.
Note: This setting is switched back to GENLOCK off after
the IVS is started (after power down/power up)
to avoid accidental operation.
Video-A
ss
is
t-Sy
stem
MENU VIDEO/TEXT ADJUST
- FLICKERFREE ON
- LINE INTERP. ON
- SHARPNESS 2
- BNC OUT VBS
Y/C DATA
-> - GENLOCK ON
- MINI MON DATA ON
- TXT WHITE LEV. 2
- TXT INVERS OFF
- TXT FINE POS 2
- EXIT