ARRI ARRIFLEX 416 - Manual (Page 56)


 
Running the Camera
If the operation control indicator glows red while in Standby,
the camera is not ready and will not run (see “Overview
of Display Symbols”).
• Briefly press the “RUN” button. While the camera is
running up to speed, the operation control indicator
a photo glows red. Once the set frame rate has been
reached, the operation control indicator turns green.
Note: If the “PHASE” button has not been pushed after
power on or after a new magazine has been
attached, the first time “RUN” is pressed the camera
performs a 2 second loop check before running.
Stopping the Camera
• Press the “RUN” button again a photo briefly. While
the camera is slowing down the operation control
indicator glows red. The mirror shutter automatically stops
in a position that enables unrestricted viewing through
the viewfinder. On reaching this position, the operation
control indicator flashes green before going out.
Camera
Operation
RUN button
RUN button
phase button
SEL/SET
buttons
operational control indicator
black bar
to indicate
Mode 1