ARRI ARRIFLEX 416 - Manual (Page 53)


 
Note: The automatic image compensation locks in two
positions 180° apart. This allows the image
compensation to be set to provide an upright
image when using a finder extension.
If the viewfinder image is inverted without the finder
extension, the image compensation must be adjusted to
the opposite locking position.
Inverting the Image
• Press the locking button a photo and keep pressed.
• Turn the adjustment knob a photo .
• Release the locking button a photo .
• Keep turning the adjustment knob a photo until the
locking button pops up and the adjustment knob locks
in position.
Removing the Viewfinder System
Before removing the viewfinder system, the viewfinder
arm should be brought back to its normal position.
• Loosen the three fastening screws a photo .
• Pull the viewfinder system up and off the camera body.
• If the camera is to be used without the viewfinder, fit
the cover to protect the beamsplitter prism.
Attaching the Viewfinder System
• Position the viewfinder system on the camera body
from above.
• Tighten the fastening screws.
Viewfinder Warnings
A LED glows when the camera is not running at the set
speed (ASY). This LED blinks when the battery voltage is
low (BAT).
Optic
s
screws
locking button
adjustment knob