ARRI ARRIFLEX 416 - Manual (Page 130)


10 10
Position – Adjusting the position of the Format Markings
The format markings can be adjusted to suit any format. The
format markings on the fibre screen serve as a reference.
To align format 1, make sure that FORMAT 1 or FORMAT
1&2 is selected. To align format 2, make sure that
FORMAT 2 or FORMAT 1&2 is selected.
MENU FORMAT MARKING
- FORMAT 1&2
-> - POSITION 1 Ö
- POSITION 1 Ü
- POSITION 2 Ö
- POSITION 2 Ü
- WHITE LEVEL 2
- OUTSIDE LIGHT
- EXIT
Video-A
ss
is
t-Sy
stem
To match the electronic format markings with the fibre
screen markings proceed as follows:
• Point the film camera towards a bright object so that the
format markings on the fibre screen are clearly visible.
These are best seen if the camera lens is thrown out of focus.
• Move the cursor > with the keys Ê and Ë to the line
– POSITION 1Ö or – POSITION 2Ö, depending on
whether format 1 or format 2 is to be adjusted. The
symbol Ö indicates that the top line and the left line can
be moved. Enter the positioning mode by pressing the
keys Í or Ì.The display will show
<>^vE
. To move
the top line up and down, use the keys Ê and Ë.
When the desired position has been set, press the key
Ñ to leave the positioning mode. To move the
vertical line left and right, use the keys Í or Ì.
• Move the cursor > with the keys Ê and Ë to the line
– POSITION 1Ü or – POSITION 2Ü, depending on
whether format 1 or format 2 should get adjusted. The
symbol Ü indicates that the lower line can be moved.
Enter the positioning mode by pressing the keys Í or
Ì .The display will show <>^vE . To move the top line
up and down, use the keys Ê and Ë. When the the
desired position has been set, press the key Ñ to
leave the positioning mode. To move the vertical line
left and right, use the keys Í or М.