ARRI ARRIFLEX 416 - Manual (Page 82)


 
Video-A
ss
is
t-Sy
stem
Black and White Output
The Y part of the Y/C output is a standard black and white
signal. To get black and white, use a standard BNC cable
with 75 Ω connected to the É/Y output and switch to Y/C
out.
Black and white or Y signal is only available if
the output is switched to Y/C out.
• Use the on-screen program mode to switch between
composite and Y/C. Enter the main menu by pressing
the Enter/Insert key Ñ for more than 3 seconds. Go
to sub menu VIDEO/TEXT ADJUST. The menu line BNC
OUT can be switched between VBS and Y/C.
See chapter 10.4 Inserter Facilities for information on
the on-screen program mode.
There are clean video and video with data signals
available from the same connector.
MENU VIDEO/TEXT ADJUST
- FLICKERFREE ON
- LINE INTERP. ON
- SHARPNESS 2
-> - BNC OUT Y/C
- Y/C DATA OFF
- GENLOCK OFF
- MINI MON DATA ON
- TXT WHITE LEV. 2
- TXT INVERS OFF
- TXT FINE POS. 2
- EXIT