ARRI ARRIFLEX 416 - Manual (Page 84)


 
Mini-Monitor Outputs
The IVS has two mini-monitor connectors. Typically one
might be used for a standard mini-monitor and the other
for a video transmitter.
It is possible to switch between normal video and video
with data on the Mini-Monitor output.
• To switch between normal video and video with data
on the mini monitor outputs, use the on-screen
program mode. Enter the main menu by pressing the
Enter/Insert key Ñ for more than 3 seconds. Go to
sub menu VIDEO/TEXT ADJUST. The menu line MINI
MON DATA can be switched OFF and ON.
See chapter 10.4 Inserter Facilities for information on
the on-screen program mode.
Video-A
ss
is
t-Sy
stem
Pin-Outs Mini Monitor Connector (seen from outside)
Signal Shield
Pin 2
GND
Pin 1
Composite Video
Pin 3
+12 V
Pin 4
Note: Maximum combined output for the Mini-Monitor
connectors is 3 A (36 W).
mini monitor connectors
MENU VIDEO/TEXT ADJUST
- FLICKERFREE ON
- LINE INTERP. ON
- SHARPNESS 2
- BNC OUT Y/C
- Y/C DATA ON
- GENLOCK OFF
-> - MINI MON DATA ON
- TXT WHITE LEV. 2
- TXT INVERS OFF
- TXT FINE POS. 2
- EXIT