ARRI ARRIFLEX 416 - Manual (Page 38)


 
• Hold the film between thumb and middle finger of your
left hand, while using your index finger to push the film
head into the lower magazine throat slot. The angle at
which the film enters is not as critical as it is on the old
SR magazines.
• Keep pushing the film in with your index finger until
you see the sprockets rotate a photo . Now take hold
of the film core again and rotate it counter-clockwise.
This will pull the film from the throat into the take-up
chamber.
• Thread the film around the rear guide roller following
the path indicated in the magazine.
• Insert the film head into the film core and manually
wind the core holder two or three turns until the film
winds tightly onto the core.
• Unlatch the lay-on roller arm.
• Close and lock the take-up side door.
• If using timecode, set the sensitivity switch according to
the table In the Timecode section of this manual. The
switch is located at the top left corner of the feed side
door a photo .
film core
lower
magazine
throat
film core slit lay-on roller arm
Timecode sensitivity switch
Magazine
s