ARRI ARRIFLEX 416 - Manual (Page 44)


 
• Turn the shutter tool to set the shutter to the desired
shutter opening. The shutter is held in its preset
positions by a sprung-ball, which can be felt as the
shutter is adjusted. Make sure the shutter registers
properly at the set opening.
• Remove the shutter tool and film track cleaning rod
Operation of the camera when the mirror
shutter is not correctly locked in position may
cause incorrect exposure!
Shutter Angle Measurement
• Holding the “PHASE” button pressed in Standby will
make the camera inch forward.
• During this the display shows the measured shutter
angle in the upper line. The lower line displays the
voltage of the power supply or the percentage of
remaining battery capacity or the number of magazine
rolls left.
phase button
Camera
Body