ARRI ARRIFLEX 416 - Manual (Page 58)


 
Overview of Display Modes
Mode 1 is displayed:
after switching on the camera,
after pressing the “RUN” button
or 30 seconds after the last operation.
1st Display Line 2nd Display Line Adjustment Possibility
Mode 1 total exposed film counter (m/ft) or frame rate (fps) or setting/re-setting of total exposed film counter
take counter (m/ft) ESU in standby and selection of a standard frame rate
frame rate (fps) while running
(external control connected)
Mode 2 programmed frame rate (PS) programmed frame rate (fps) programmed frame rate
ESU – external control connected
Mode 3 total exposed film counter (m/ft) or power supply voltage (V), or (with unit of measurement (m/ft)
take-counter (m/ft) OBB-2 fitted) capacity in percent configuration of the film counter
or remaining magazines press SET to set battery warning level
Mode 4 timecode hours:minutes timecode seconds:frame rate press and hold SET for 3 seconds to turn TC on/off
press SEL to show TC error codes press SEL to show TCS settings press and hold SEL and then
and activity of clock adjustment press and hold SET for 3 seconds to reset clock
adjustment to default
Mode 5 timecode user bits (1st 4 digits) timecode user bits (2nd 4 digits) setting of user bits (0-9, A-F)
Mode 6 sequence and volume of the acoustic brightness of the keypad beep at start, stop, neither or both
warning signal beeper volume
keypad backlight brightness
Mode 7 GLo – RGB ARRIGLOW ARRIGLOW color preset colors 1-8 and User adjustable color
r, G & B values (0-16) for User color r, G & B values (0-16) for User color
Camera
Operation