ARRI ARRIFLEX 416 - Manual (Page 47)


 
7.4 Attaching the Magazine
• Move the magazine release lever safety catch to the
open position a photo .
• Press down the magazine release lever a photo and
remove the magazine opening cover.
• Remove the loop protector from the magazine.
• Place the magazine’s throat in the camera opening and
slide the magazine forward into the camera until it latches.
• Flip the magazine release lever safety catch forward to
prevent accidental release of the magazine.
• Press the “PHASE” button for a couple of seconds to
inch the film.
Note: After a new magazine has been attached or after
camera power has been turned on, you should
always push the “PHASE” button to perform a loop
check (the display shows “LooP“). This takes about
2 seconds and will engage the pull down claw,
check loop size and centre the loop properly.
Note: If the loop check finds that the loop is too short for
safe camera performance the message “Error
LooP.S“ will show in the camera display. The camera
is not ready and will not run. If the loop check
finds that the loop is too long for safe camera
performance the message “Error LooP.L“ will show
in the camera display. The camera is not ready
and will not run.
Camera
Body
release lever
release lever
safety catch