ARRI ARRIFLEX 416 - Manual (Page 187)


1
Channel Use
0 2444 - 2472 MHz
1 2406 - 2435 MHz
2 2444 - 2472 MHz
3 2406 - 2435 MHz
4 2444 - 2472 MHz
5 2406 - 2435 MHz
6 2444 - 2472 MHz
7 2406 - 2435 MHz
8 Not used
9 Radio device deactivated
• Set the channel selection switch on the camera to the new
channel – the RF LED goes red. Then turn the camera
off and back on again after approximately 5 seconds.
LED Color Status
Off Wireless deactivated (channel 9 selected)
or camera deactivated
or camera has no power
Alternating Radio modem is being initialised.
red/green Do not activate the WMU yet.
Green blinking Radio modem is ready, activate the WMU
Green Wireless remote control OK
Red Channel selection switch has been changed.
Wireless remote control will continue to function but the
channel will be changed the next time it is switched on.
-> Reset to the previously selected channel if the change
was unintentional, or turn module off and on again
to change channel.
Red blinking Hardware error in radio module.
If this error persists after restarting the camera,
send the camera for service.
Red blinking rapidly Radio fault: another ARRI wireless system
is on the same channel nearby. Select another channel.
Note: If two yellow washer remote systems are on the
same set, it is recommended to set one system to
an even channel and the other to an odd channel.
Only odd numbered channels are legally
permitted for use in France
To change the radio channel:
• With the camera off, set the channel and then turn the
camera on. Or,
• Move the channel selection switch to 9 (deactivated) and
then turn it to the required channel within half a second.
Or,
The RDY LED of the radio system a photo indicates the
status of the radio as follows:
ARRIFLEX

1

Plu
s