ARRI ARRIFLEX 416 - Manual (Page 63)


 
Setting a Programmed Frame Rate (Mode 2)
Standby Operation
• Change from Mode 1 to Mode 2 by pressing the
“MODE” button once.
• Press the “SEL” button repeatedly until the digit to be
set blinks.
• Press the “SET” button repeatedly until the desired
value is reached.
• Repeat this procedure until all digits are set to the
desired values. A final confirmation of the set frame
rate is not necessary.
Note: The frame rate can be set between 1 and 75
fps forward only.
Note: The programmed frame rate is stored in non-
volatile memory (which means it is retained
even when the camera is without power).
Changing the Frame Rate while the Camera is running
By means of the “NORM” and “PS/CCU” buttons it is
possible to switch between the standard frame rate
(“NORM”) and the programmed frame rate (“PS/CCU”)
while the camera is running.
Fine Tuning the Programmed Frame Rate (PS Mode)
Fine tuning of the programmed frame rate can be carried
out while the camera is running by means of the buttons
“SEL” (slower) and “SET” (faster). The setting can be
adjusted in increments of 0.001 fps.
• Ensure the camera is in “PS/CCU” mode.
• Run the camera.
• Press the “MODE” button once to change to Mode 2.
• With the buttons “SEL” (slower) and “SET” (faster)
change the frame rate.
Camera
Operation