CiDRA SONARtrac PW VF-100 - Manual (Page 50)

20831-01 Rev 05 Page 5-32
5.7.2 Stainless Steel Cover Model SH-XXX-XX-02(or 05 or 32)-
XXX-XX Installation
This section covers installation of Stainless Steel Covers Model
Numbers SH-xxx-xx-02-xxx-xx or SH-xxx-xx-05-xxx-xx or SH-xxx-xx-
32-xxx-xx
, where “x” is any alphanumeric character.
The stainless steel cover is illustrated in the following figure.
Figure 33 Stainless Steel Cover Assembly
WARNING
The handles on the stainless steel cover are not designed or
rated for hoisting the cover. Use a proper lifting sling to
properly secure cover to lifting rope when hoisting cover.
Important: A banding tool is needed to properly install stainless steel
sensor cover sizes 18-inch and larger. Failure to use a banding tool
may result in improper sensor cover to pipe sealing and will void the
system warranty. The use of a BAND-IT
®
Model C00169 Banding
Tool (or equivalent) is recommended. The tool is available through
Customer Support as P/N 52511-01. This tool is also available in the
United States from McMaster Carr Company (telephone 630-833-
0300, internet www.mcmaster.com) as their P/N 5424K1. Other
suppliers are available worldwide. Contact BAND-IT at 800-525-0758
or 303-320-4555 or www.band-it-idex.com.
Upper cover assembly
Lower cover assembly
Transmitter cable connector
socket Sensor cable access panel
Cover lifting handles (4 plcs)
Boot Gasket (upper &
lower covers