CiDRA SONARtrac PW VF-100 - Manual (Page 51)

20831-01 Rev 05 Page 5-33
Figure 34 BAND-IT
®
Model C00169 Banding Tool
CAUTION
Use of a BAND-IT
®
Model C00169 Banding Tool (or equivalent) is
necessary for properly installing sensor cover. Failure to use
this tool may void system warranty.
Remove the sensor cable access panel on the cover and place the
upper cover assembly on the pipe. Note: Ensure the sensor cable
connector is accessible through the sensor cable access panel. (If
necessary reposition cover or cable connector.)
Place the lower cover on the pipe and retain the cover halves with
spring clamps or vice grips. Install and tighten the cover bolts 1
– 2
turns. (The stainless cover will either have a fastener assembly
consisting of a bolt, 2 washers, a lock washer and locknut, or, a bolt
with one washer and the nut retained in the lower cover flange.)
Continue to tighten the cover bolts until the flanges bottom on the
spacers integral to the flange and flange seal.
Apply a coating of the Joining Compound (comes in the Installation
Kit) to the flange seal and boot gasket at the edge of the lower cover
(4 places). Press the upper boot gasket and Joining Compound
coated lower seal edges together.
Figure 35 Applying Joining Compound to Gasket Edge
Apply coating of
joining compound