CiDRA SONARtrac PW VF-100 - Manual (Page 46)

20831-01 Rev 05 Page 5-28
5.7.1.4 Boot Seal Clamp and Band Installation
The boot seal clamp or band is used to seal the cover boot seal to the
process pipe. Cover sizes 2-inch through 8-inch use a stainless steel
T-bolt saddle clamp. Cover sizes 10-inch and larger use a stainless
steel band and buckle fastener. These are illustrated in the following
figures.
NOTE: Always install the upper boot seal clamp first on vertical pipe
installations.
Figure 24 Tee-Bolt Saddle Clamp
Figure 25 Boot Seal Band
5.7.1.4.1 Tee-Bolt Saddle Clamp
The tee-bolt saddle clamp used on cover sizes up to 8-inch is
wrapped around the boot seal. Locate the tightening bolt such that it
is in-line with the access cover on the upper cover assembly. Ensure
the saddle clamp is located within the groove on the boot seal.
Tighten the nut until the seal fits snug to the pipe. Repeat at the
opposite end of the pipe.
Figure 26 Tee-Bolt Saddle Clamp
Pre-installed buckle