CiDRA SONARtrac PW VF-100 - Manual (Page 60)

20831-01 Rev 05 Page 5-42
5.7.6 Sensor Calibration Label
The sensor band is shipped with two labels enclosed with it. The label
lists the sensor part number, serial number, date of manufacture and
three calibration factors. This information will be entered into the
transmitter during setup. Affix one of the labels to the outside of the
access panel of the sensor cover as shown below.
The second label should be installed on the inside of the transmitter
cover.
Note: Sensor band
information is also
found on a label on
the sensor cable next
to the sensor cable
connector.
Figure 47 Sensor Calibration Label