CiDRA SONARtrac PW VF-100 - Manual (Page 73)

20832-01 Rev 05 Page 6-7
6.2.2 Pipe Mounting
The optional Pipe Mount Kit is designed to allow for mounting the
transmitter assembly to pipes up to 10-inch (250 mm) diameter and
equivalent sized I-beams. The kit consists of two mounting rails, two
band clamps, and fasteners. (Additional lengths of clamps can be
added for larger diameter pipes and I-beams. Please contact your
local distributor or Customer Support for more information.)
Figure 2 Pole Mount Kit
Attach the mounting rails to the panel mounting feet using the 1/4-20 x
3/4” screws and locknuts supplied with the rails. Slide the band
clamps through the slots in the mounting rails as shown. Wrap the
clamp around the pipe and feed the band through the clamp and
tighten. Excess band material can be removed if desired.