Rockwell Automation 1336 8A-48A Fiber Industry - Manual (Page 53)

3–13 Human Interface Module
Password Mode
or
or
or
or
and
1. The factory default password is 0 (which
disables password protection). To change
the password and enable password
protection, perform the following steps.
A. From the Status Display, press Enter
(or any key). “Choose Mode” will be
shown.
B. Press the Increment (or Decrement)
key until “Password” is displayed.
C. Press Enter.
D. Press the Increment (or Decrement)
key until “Modify” is displayed.
E. Press Enter. “Enter Password” will be
displayed.
F. Press the Increment (or Decrement)
key to scroll to your desired new
password. With a Series A (version
3.0) or Series B HIM, the SELect key
will move the cursor.
G. Press Enter to save your new pass-
word.
H. Press Enter again to return to the
Password Mode.
I. Press the Increment (or Decrement)
key until “Logout” is displayed.
J. Press Enter to log out of the Password
mode.
K. With a Series A (version 3.0) or Series
B HIM, the Password mode can be
programmed to appear when drive
power is applied. Simultaneously press
the Increment and Decrement keys
while the Password display is shown. Sets Password Display
as Power-Up Display
Choose Mode
Password
Choose Mode
Display
Password
Modify
Enter Password
< 0>
Enter Password
< 123>
Choose Mode
Password
Password
Login
Password
Logout
Choose Mode
Password