Rockwell Automation 1336 3-20HP FRN 1.01-3.01 - Manual (Page 117)

Logic Interface Options
Appendix A
A-16
1336ĆMODĆL3 115V AC
Important: Control functions affected by drive Parameter programming
Logic Interface Board
and selection are indicated on the following pages. Refer to the 1336
Programming Manual to verify that the drive is programmed to meet your
requirements.
If two-wire control is installed, option L1, L2 or L3 must also be installed.
The 2-wire scheme allows a fault to be cleared by cycling the start/stop
contact if the following is true:
•
Parameter 14 = 1
•
Parameter 39 = 1
If Parameter 14 is not set to “1”, the drive can remain in an “F11” loop.
Power must then be cycled in order to clear the fault.
!
ATTENTION: Unexpected machine motion can cause injury or
death. Do not use a Local or Remote Control Panel with option L1,
L2, or L3 in any 2-wire start/stop control application.
A maintained start command or 2-wire control between terminals
19 and 20 of TB3 on option L1, L2 or L3 will affect Control Panel
stop pushbutton operation. The drive will automatically restart after
the Control Panel stop pushbutton is depressed and released.
Terminal 19 and Interface Common
Start
Momentary True = Start
False = Continue Last State
This input will command the drive to start if all hardwired interlocks are
closed. The drive will continue to run until a stop command is received, an
interlock is opened, or a fault is detected. A maintained True state is not
required to keep the drive running but is permitted. A False state is
required to allow the drive to respond to a momentary stop input.
Terminal 20 and Interface Common
(This signal must be maintained as True to permit the drive to operate from any
control source.)
Stop
Maintained True = Not Stop
Momentary False = Stop
Stop must be a maintained True input to permit the drive to start and run. A
momentary False of 90mS or more or any other drive stop command will
initiate a drive stop sequence as programmed by Parameter 10, Stop Select.