Fault display, Parameter programming display, Operating display – Rockwell Automation 1336 3-20HP FRN 1.01-3.01 User Manual
Page 75: Parameter viewing display
Operation
Chapter 7
7-5
Fault Display
Fault codes appear if the drive detects a fault condition.
Freq
P
R
Parameter Programming Display
Parameter values appear when viewing or programming drive parameters.
Freq
P
R
Operating Display
The Pr display is a two character display that shows the frequency source
when the drive is in Standby, Jog or Running.
Freq
P
R
– 0 Control Panel speed pot
– 5 TB2 speed pot input
– 1 0 to +10V input
– 6 Jog selected
– 2 4-20mA input
– 7 Preset Speed 1
– 3 Pulse train input
– 8 Preset Speed 2
– 4 Serial input
– 9 Preset Speed 3 or if Parameter 72 is
set to 1, Preset Speeds 4-7
Important: No dash indicates a parameter number rather than a frequency
source.
Parameter Viewing Display
The parameter number appears when viewing parameters.
Freq
P
R