Parameter programming, Fault display, Special display enable loss – Rockwell Automation 1336 3-20HP FRN 1.01-3.01 User Manual
Page 76: Special display ċ enable loss, Two dashes appear if a fault has occurred, All dashes appear if an enable loss has occurred
Advertising
Operation
Chapter 7
7-6
Parameter Programming
A decimal point appears if parameter programming has been selected and
is allowed. If the programming function is locked out, check switch SW1
on the Local Display and Programming Panel Card, option FA2. The
switch must be set to C1 to allow parameter programming.
Freq
P
R
Fault Display
Two dashes appear if a fault has occurred.
Freq
P
R
Special Display Ċ Enable Loss
All dashes appear if an enable loss has occurred.
Freq
P
R
Advertising