Bio-Rad Quantity One 1-D Analysis Software - Manual (Page 306)

E-1
Appendix E
GS-710 Imaging Densitometer
Fig. E-1. GS-710 Imaging Densitometer
Before you can begin scanning images with the GS-710 Imaging Densitometer
®
, your
instrument must be properly installed and connected with the host computer. See the
hardware manual for installation, startup, and operating instructions.
PC Only: A Note About SCSI Cards
The GS-710 is connected to your computer by a Small Computer System Interface
(SCSI) cable. To use the GS-710, you must have a SCSI card installed in your PC. If
you have a PC with a Windows 98 or Windows ME operating system, you may also
need to load the SCSI and WinASPI drivers that came with the card.
Simulation Mode
Any of the imaging device acquisition windows can be opened in “simulation mode.”
In this mode, an acquisition window will open and the controls will appear active, but