Bio-Rad Quantity One 1-D Analysis Software - Manual (Page 386)

Appendix J. FX
J-5
Fig. J-3. Enabling Channel 2.
Enabled channels have a green check mark on their tabs.
You do not need to enable Channels 2–4 in sequence. For example, you can set up
your four most common applications using the different channels, but only enable
Channel 4 for a particular gel. Channel 1 would be scanned first, Channel 4 second.
Enabled channels are scanned sequentially. The separate scans are displayed and
saved as separate images. The total scanning time depends on the number and type of
enabled applications.
If you have selected Auto Save After Scan, the image created using Channel 1 will
have the base file name, and images created using subsequent channels will have the
base file name plus a version number. (v. 2, v. 3, v. 4). Note that the image version
number does not necessarily correspond to the channel number. For example, if you
scanned an image using only Channels 1 and 4, the image created using Channel 4
will be saved as version 2 (v. 2).
J.2.b Selecting an Application
To select an application (i.e., the appropriate filter and other parameters for the type of
object you are imaging), click on the Select button under a channel tab.
Select the checkbox
to enable the channel
Click on the Select
button to select the
application
Click on the tab to
select the channel