Bio-Rad Quantity One 1-D Analysis Software User Manual
Page 360
Appendix H. Fluor-S MAX
H-5
Custom Applications
If your application is not listed, if you want to use a user-installed filter, or if you want
to access Ultra Sensitivity mode (see below), you can create and save your own
custom application.
From the application tree, select Custom, then Create. This will open a dialog box in
which you can name your application and select your settings.
Fig.H-4. Creating a new custom application.
To select the filter (including user-defined), type of illumination, and camera mode,
click on the appropriate buttons.
Note:
Under Illumination, there is a listing for a spare UV light source. This selects the
spare UV bulb in the Fluor-S MAX. Select this light source if your main UV bulb
fails.
Enter a name for your application in the Name field. Click on OK to implement your
changes.
After you have created an application, you can select it from the application tree by
selecting Custom and the name you created. You can delete the application by
selecting Custom, Delete, and the name of the application.