Rice Lake 520 HMI Digital Weight Indicator Installation Manual - Manual (Page 20)

Installation 14
2.9 Replacement Parts
Table 2-9 lists replacement parts common to both models of the 520 , including all parts referenced in Figure 2-9 on
page 15. Refer to Table 2-9 on page 16 for replacement parts specific to the desktop model.
Table 2-8. Panel Mount Replacement Parts
Ref Number PN Description (Quantity)
1 41401 Enclosure (1)
1 68719 Faceplate gasket
2 68718 Membrane switch overlay
3 68717 Shroud
4 68716 Faceplate
5 75063 Board, assembly 115V
- 75064 Board, assembly 230V North America
- 75065 CPU board assembly, 230V European
7 42640 Screw, 1/4-28 NF x 1/4
8 15626 Cable, grip black PG9
9 15627 Locknut, black PCN9
10 14839 Screw, 6-32NC x 1/4
11 14822 Screw, 4-40NC x 1/4
12 69031 Power cord assembly
13 15631 Cable tie, 3 inch nylon
14 15134 Washer, lock no. 8, type A
15 45043 Ground wire, 4 inch w/no. 8 eye connector
16 14626 Kep nuts, 8-32NC hex (3)
17 14621 Kep nuts, 6-32NC hex (4)
18 16892 Earth ground label
- 50532 Bezel (1)
19 69091 Display ribbon cable
21 53308 Label roll, 1.25 x 1.25
22 69291 **CR1632 lithium coin battery
23 53307 Label, 4.000 x 2.875
24 54356 Screw, 8-32NC x 3/8
25 71001 Polycarbonate lens
- 45076 Bezel gasket (1)
27 71616 520 J1-J3 connector label
- 45484 **160 mA time-lag TR5 type fuse - 115V unit (Rev A, B, C, D)
- 68659 **315 mA time-lag TR5 type fuse-115V unit (Rev E and above) 1
- 73001 **Fuse - 230V unit North American
- 45107 **Fuse - 230V unit European
* Additional parts included in parts kit. See Section 2.1.1 on page 5 for additional parts information.
CAUTION
** To protect against the risk of fire, replace fuses only with same type and rating fuse. See Section
12.14 on page 87 for complete fuse specifications. There is a risk of explosion if battery is replaced by
an incorrect type.
Revision E and higher boards use fuse 68659, 315mA to meet UL requirements.