Rice Lake 520 HMI Digital Weight Indicator Installation Manual - Manual (Page 44)

Configuration 38
3.2.8 Digital Input Menu
9999999 9999999 9999999
%*(*/
#"54535
#"51"64
(3044
$-3$/
/&5
13*.
"-(065 %*(
*/ 4&5154 130(3. 1'03.5 4&3*"- $"-*#3 $0/'*( '03."5
%*(*/
7&34
$-3
"$$
6/*54
5"3&
/5(34
0''
;&30
13*/5
$-3
5"3
4&$
%*(*/
%415"3
"$$6.
&/5&3
,#%-0$
)0-%
#"536/
0''
;&30
5"3&
/5(34
6/*54
13*/5
&/5&3
#"51"64
#"54535
#"536/
,#%-0$
)0-%
$-3$/
"$$6.
%415"3
(3044
/&5
13*.
4&$
$-3
5"3
$-3
"$$
#"536/
#"54535
$-3$/
#"51"64
(3044
/&5
$-3
5"3
5"3&
/5(34
;&30
$-3
"$$
0''
6/*54
4&$
13*.
13*/5
%415"3
"$$6.
&/5&3
,#%-0$
)0-%
Figure 3-16. Digital Input Menu
DIG IN Menu
Parameter Choices Description
Level 2 submenus
DIGIN1
DIGIN2
DIGIN3 OFF
ZERO
NT/GRS
TARE
UNITS
PRINT
ACCUM
DSPTAR
ENTER
KBDLOC
HOLD
BATRUN
BATSTRT
BATPAUS
CLRCN
GROSS
NET
PRIM
SEC
CLRTAR
CLRACC Specifies the function activated by digital inputs 1–3. Default values are: DIGIN1=BATSTRT;
DIGIN2=BATRUN; DIGIN3=OFF.
• ZERO, NT/GRS (net/gross mode toggle), TARE, UNITS, and PRINT provide the same
functions as the five front panel keys.
• ACCUM displays the current accumulator value.
• DSPTAR displays the tare.
• ENTER simulates pressing the ENTER key in weigh mode (for setpoint and checkweigh
value changes from the front panel).
• BATRUN allows a batch routine to be started and run. With BATRUN active (low), the
BATSTRT input starts the batch; if BATRUN is inactive (high), BATSTRT cancels the batch.
• BATSTRT starts or ends a batch routine, depending on the state of the BATRUN input.
• BATPAUS pauses a batch routine when held low.
• KBDLOC locks the keyboard (indicator front panel) when held low.
• HOLD holds the current display. Releasing this input clears the running average filter.
• CLRCN resets the consecutive number to the value specified on the CONSTUP parameter
(PROGRM menu).
• GROSS, NET, PRIM, and SEC select gross, net, primary units, or secondary units display
modes.
• CLRTAR clears the current tare.
• CLRACC clears the accumulator.
Table 3-8. Digital Input Menu Parameters