Rice Lake 520 HMI Digital Weight Indicator Installation Manual User Manual
Page 54
Checkweigh Mode
48
Checkweighing Operations
To display a checkweigh value, enter front panel setup
mode. Hold the
UNITS
key for five seconds. To exit the
bargraph mode, press the key at any prompt. If no
keys are pressed for 10 seconds, the program times out
and exits.
Use the procedure shown in Figure 7-2 to enter the
actual checkweigh value
8IFOFEJUJOHOVNFSJDWBMVFT QSFTT
PS
UPDIBOHFUIF
EJHJUTFMFDUFE1SFTT
PS
UPJODSFNFOUPSEFDSFNFOUUIF
WBMVFPGUIFTFMFDUFEEJHJU*GBEFDJNBMQPJOUJTSFRVJSFEJOWBMVF
QSFTTUPWJFXBOENPWFEFDJNBMQPJOU1SFTT PS
UP
NPWFEFDJNBMQPTJUJPO1SFTT UPTBWFUIFWBMVFFOUFSFEBOE
SFUVSOUPUIFMFWFMBCPWF
Note
If the checkweigh function is enabled, setpoints
remain configured but do not function until
checkweigh is disabled.
Figure 7-2. Editing Procedure for Numeric Values